Verbtone 1.1.0
02 mar 2016

Description:

- It is a physical model of a plate reverb, plus some useful add-ons.
- It is non-linear with strong input, so input and output level controls

Parameters:

- Gain: input signal gain
- Volume: reverb output level, PRE-mix!

- Width: FINAL width of reverb tail. Reverb starts stereo (if stereo mode is set) and
evolves, ending with "Width" stereo width). Set it to max and use external pan/width control for fixed width control

- Low: hi-pass filter
- High: lo-pass filter
- Delay: predelay
- Length: reverb duration
- Sound: sets internal parameters, from a thinner plate to a thicker plate
- Tune: sets internal parameters, from lighter to heavier plate
- Vel: stereo modulation velocity
- Mod: stereo modulation amount
- Mix: mixes dry signal and reverb (reverb is post-Volume)

- Stereo menu:
Stereo->Mono->Stereo: mixes L and R to mono, then generates a stereo reverb
Split Stereo: processes L and R through two parallel plates
True Stereo: like Split Stereo but interconnects the channels/plates
Cross Split Stereo: Like Split Stereo but L and Right are inverted
Panned (Width) Mono: mixes L and R to mono and feeds both channels with mono
	(may become pseudo-stereo with modulation).
	Width knob becomes reverb pan!!!
NEW - Follow the source. The reverb comes from the same direction as the source.
Try it when sending several sources to the same instance, each one with its
own panning.

- Modulation menu:
Amplitude: modulates reverb's amplitude
Frequency: applies a chorus to reverb
Phase: modulates reverb's phase (choruses with dry signal)
Pan: modulated reverb's pan

TAP on plate to hear its sound while looking for a new reverb and changing parameters!